As of January 1, 2018, the new USA Baseball Bat Standard was implemented. USABat Standard bats must be used in the Little League Major Baseball Division and below. Either USABat Standard bats or BBCOR bats must be used at the Intermediate (50/70) Baseball and
Junior League Baseball Divisions. At the Senior League Baseball Division, all bats must meet the BBCOR standard. For more information on the USABat standard and a complete list of bats approved through the USABat Standard, visit usabat.com
Rule 1.10 – Baseball
The bat must be a baseball bat that meets the USA Baseball Bat standard (USABat) as adopted by Little League. It shall be a smooth, rounded stick, and made of wood or of material and color tested and proved acceptable to the USA Baseball Bat standard (USABat).
Beginning with the 2018 season, non-wood and laminated bats used in the Little League (Majors) and below, Intermediate (50-70) Division, Junior League divisions, and Challenger division shall bear the USA Baseball logo signifying that the bat meets the USABat – USA Baseball’s Youth Bat Performance Standard. All BPF – 1.15 bats will be prohibited beginning with the 2018 season. Additionally, starting in 2018, the bat diameter shall not exceed 2⅝ inches for these divisions of play. Bats meeting the Batted Ball Coefficient of Restitution (BBCOR) standard may also be used in the Intermediate (50-70) Division and Junior League divisions. Additional information is available at LittleLeague.org/batinfo.
All Bats MUST HAVE the USA or BBCOR logos printed on the bat
Bats with the USSSA BBF below logo are prohibited
Minor/Major Divisions (CP, AA, AAA, Majors):
It shall not be more than 33 inches in length; nor more than 2⅝ inches in diameter, and if wood, not less than fifteen-sixteenths (15/16) inches in diameter (7/8 inch for bats less than 30″) at its smallest part. Wood bats taped or fitted with a sleeve may not exceed sixteen (16) inches from the small end.
NOTE 1: Solid one-piece wood barrel bats do not require a USA Baseball logo.
NOTE 2: BRLL Coach Pitch Division is not using Tee Balls so bats labeled "TBall" or "Approved for use with TBalls Only" are not allowed in our CP division. You will find a note about TBall bats being allowed in the LL Blue Book however they are only permitted when using Tee Balls.
Intermediate (50-70) Division and Junior League:
It shall not be more than 34″ inches in length; nor more than 2⅝ inches in diameter, and if wood, not less than fifteen-sixteenths (15/16) inches in diameter (7/8 inch for bats less than 30″) at its smallest part. Wood bats taped or fitted with a sleeve may not exceed eighteen (18) inches from the small end.
NOTE 1: Solid one-piece wood barrel bats do not require a USA Baseball logo.
NOTE 2: Also, permitted for the Intermediate (50-70) Division and Junior League Division are bats meeting the BBCOR performance standard, and so labeled with a silkscreen or other permanent certification mark. The certification mark shall be rectangular, a minimum of a half-inch on each side, and located on the barrel of the bat in any contrasting color. Aluminum/alloy and composite bats shall be marked as to their material makeup being aluminum/alloy or composite. This marking shall be silkscreen or other permanent certification mark, a minimum of one-half-inch on each side, and located on the barrel of the bat in any contrasting color.
Senior League:
It shall not be more than 36 inches in length, nor more than 2⅝ inches in diameter, and if wood, not less than fifteen-sixteenths (15/16) inches in diameter (7/8 inch for bats less than 30″) at its smallest part. Wood bats taped or fitted with a sleeve may not exceed eighteen (18) inches from the small end. The bat shall not weigh, numerically, more than three ounces less than the length of the bat (e.g., a 33-inch-long bat cannot weigh less than 30 ounces). All bats not made of a single piece of wood shall meet the Batted Ball Coefficient of Restitution (BBCOR) performance standard, and such bats shall be so labeled with a silkscreen or other permanent certification mark. The certification mark shall be rectangular, a minimum of a half-inch on each side, and located on the bat's barrel in any contrasting color. Aluminum/alloy and composite bats shall be marked as to their material makeup being aluminum/alloy or composite. This marking shall be silkscreen or other permanent certification mark, a minimum of one-half-inch on each side, and located on the barrel of the bat in any contrasting color.
In all divisions, non-wood bats must have a grip of cork, tape, or composition material, and must extend a minimum of 10 inches from the small end. Slippery tape or similar material is prohibited.
NOTE 1: The traditional batting donut is not permissible.
NOTE 2: The use of pine tar or any other similar adhesive substance is prohibited at all levels of Little League Baseball and Softball. The use of these substances will result in the bat being declared illegal and removed from play.
NOTE 3: Non-wood bats may develop dents from time to time. Bats that have cracks or sharp edges, or that cannot pass through the approved Little League bat ring for the appropriate division must be removed from play. The 2¼-inch bat ring must be used for bats labeled 2¼. The 2⅝-inch bat ring must be used for bats labeled 2⅝.
NOTE 4: An illegal bat must be removed. Any bat that has been altered shall be removed from play. PENALTY – See Rule – 6.06(d).
